Pill Box for your toolbox
Guys, as most of you know, the Propulse car uses a handful of different size screws as well as tiny parts. I wanted to recommend having a few pill boxes in your toolbox for your rc car. A Pill box typically has 4 1/2 inch by 1/2 inch squares to store pills in. Each little section has separate lids. There should be links for pictures below because I don't know how to get the actual pic to show up. Here a few uses:
1. If you take your car apart, the pillbox is good to keep the screws in order as you take them out of the car.
2. It separates the different size Screws as you take the car apart
3. If you need to leave during the time that you take your car apart, you close the lids without fear of the screws getting knocked off by someone.
4. Many of us have plastic bins that come in our toolboxes already, but most of the plastic divisions are a couple of inches deep and wide. That's a lot of space for 4 tiny screws. So, throw a pill box or two inside the existing plastic dividers inside your toolbox.
5. Tired of counting PINION gears everytime you install one? Label one of you pill boxes for each number of your pinion. Underneath the lid of each day, place a sticker or use a pen and write "11" and you know that the pinion in that box is the 11t pinion.
6. I keep a few in my toolbox to store screws and such in at all times. Example, motor mount screws, gears and bearings for the drive shaft, and so forth.
Hope this is a helpful piece for your toolbox.
Last edited by godisalivinggod; 07-03-2007 at 06:36 PM.
|