This thing is making me mad. Adjusting is so it is smooth makes it so it loosens up in seconds. I had to crank it down so there was very little actual diff action to get it to work. It still slips. Any tricks? There were no instructions. (I am running a brushless Mamba on 12 cells.)
Thanks.
I have the same diff, with the same problems. If I loosened it enough so that I could get decent diff action, the whole diff would slip. So, I had to tighten it down so much that it doesn't allow diff action, and now it just slides around corners. I finally just put the stock diff back in and it turns much better and haven't had any problems with it holding up.