Quote:
Originally Posted by Big-Kid
How does this beast run Study Session? And how do you keep from melting the gears and diffs?
I'm looking at the front bumper and it's looking mighty small right about now
Got any updated pix? It must be crazy fast with that C40 Hacker powered by a 2 cell. You're gonna need cement to keep those tires to the rims
|
Sorry but do not have any updated pics. I have it in the new 540i chassis. To be honest it is to hard to drive. I run with foam tires because even when I have the Lehner 540 motor in it, it was to much or even with the tiny little Mamba motor it also was to much for rubber tires. So had to switch to the foam tires. The rubber tires balloon up and shoot off the rims and that is on the ground not up in the air.
With the 540 brushless motors I have a hard time keeping the tires on the car since they just slide on so have to glue them onto the hub. I blow out the front diff's pretty easy. The rear holds up better just have to take it apart and reassemble every so often.
I do not run it to often anymore - Been messing more with my 1/10 scale onroad cars and my 1/18 offroad. After browsing around this forum the other day made me want to pull my 540 Micro back out and mess with it again. I most likely will go back to the mamba 8000kv motor though. Using the bigger LiPo pack should give me insane run times with the Mamba motor and that motor makes the car pleanty fast enough.