View Single Post
  #5  
Old 12-05-2009, 12:06 AM
makakoa808 makakoa808 is offline
Registered User
 
Join Date: Jan 2009
Posts: 77
Ok I got the Viscous Gear in to the rear diff housing and it fits perfect,
and I was able to install the Integy Mini E-Revo Diff Cup.
So it's a go.. Moving forward with the project. Now I need to do the front diffs
and work on a Mini LST Chassis that will hold the Mini E-Revo Center Trans.
Oh will also need to replace the Mini E-Revo spool with the Mini E-Revo Center diff.
Here are some pics below.

Here is the gears side by side.
Viscous gear on your left and the stock Mini LST gear on your right.


Here is another pic of the two gears side by side.


I also shimmed it. Here is a pic with the shimm in place between the bearing and gear.


Here is a pic of the viscous gear in place in the gear box.


For good measure here is a pic of the Mini LST Diff. I shimmed this as well but did not get a pic. I thought I did but did not. The shimm would go on your right between the bearing and the shaft cup.


Here is the gear box with the viscous diff installed. Also the Integy Mini E-Revo cup on the bottom and the Mini LST cup above.


And here it is with the Integy Mini E-Revo cup mounted on to the Mini LST gear box.


Here is a pic of the Mini LST rear end.. done deal with Viscous pinion gear and Integy Mini E- Revo Cup.
Reply With Quote