View Single Post
  #4  
Old 07-16-2006, 10:34 PM
alfred's Avatar
alfred alfred is offline
Super Moderator
 
Join Date: Jun 2004
Location: virginia beach
Posts: 10,128
Send a message via AIM to alfred Send a message via MSN to alfred Send a message via Yahoo to alfred
what kind of charger do you have.....you can check out the charge rate and voltage on the charger read out....cells do go bad if the load on them is just too high......and i think the motor Roelof uses is a 300bl motor.......but then again could be wrong. At what amps and mv are you charging the batts at. Usually a dead pack will hold a charge for a short time or not at all......the best way for me to test this is too run it in your model, and see how long or short the runtimes are. And as for the glitching problem what radio gear are you using....Am or Fm.....try changing out the crystal to a different freq and see if that helps.
__________________
Xray M18
MRS4-1
540 MRS4
Spektrumized

Last edited by alfred; 07-16-2006 at 10:43 PM.
Reply With Quote