View Single Post
  #20  
Old 07-01-2009, 01:49 PM
makakoa808 makakoa808 is offline
Registered User
 
Join Date: Jan 2009
Posts: 77
So I got the front end worked out.
Connected the single servo plate to the front end of the mini lst

I'm sure there are better parts and ways to do this. But to keep my cost down and save a trip to the hobby shop, I had some long screws laying around, I cut the tops off and used them as my mini lst down and dirty turnbuckles. (anyone got suggestions on what to use as turnbuckels let me know)

To connect them to the servo saver I cut up the stock servo saver the ends that screw to the ball joints... some lock tight and there you have it...

Again I'm sure there are better turnbuckles out there that you can use, these turn buckles are quick and dirty good for use as a prototype.

Basically used the stock turnbuckles from the mini lst and two long screws with the tops cut off. Later I'll find a better alternatives any suggestions.

Here are some images of my rccustomzone single servo mod. So far so good.




Reply With Quote