View Full Version : IM SO STUPID!! I bought a HPI ONE WAY!
Greg53
02-09-2002, 07:49 PM
I cought the hpi one way thinking it would be fine.
Well... ive only used the one way 5 battery packs.... and the little prongs on the inside diff holding thing.. that the purple slids over broke Right off... both of them flush. I should have just bought the GPM ONE! CHEAPER AND better.
This whole Front end HPI Did a Crappy job on.
Ive broke
nuckles
drive shafts
rims
Diffs x2
Diff case
pulley
Ill be going up to my lhs 2marrow...calling hpi monday....and not driving my micro 2 night!
Kingtooshy
02-09-2002, 07:55 PM
u must suck at driffing ive jumped my micro 3+feet in the air and smacke into walls using 12 cells and not broke a thing
runtracer
02-09-2002, 10:40 PM
disnt someone say that the gpm has the same plastic prongs? i think their first batch had aluminum ones then they switched to plastic. ill have to go look at the old forums to be sure.
Woody
02-09-2002, 10:56 PM
The HPI one way is fine. If you boil the housing in water for about 15 minutes the whole thing will be more rigid. I actually went a step beyond and had mine drilled to accept two screws in place of the little "ears". It's virually bullet proof now. One thing about the GPM one-way, use lots and lots of grease.
runtracer
02-09-2002, 11:00 PM
i couldnt find the post i was looking for and was getting ready to mention that someone had drilled theirs out, but i was too late!
Turbo Cloud
02-09-2002, 11:36 PM
They should have PLAINLY MADE IT BETTER!?!?!
Greg53
02-10-2002, 11:25 AM
Originally posted by Kingtooshy
u must suck at driffing ive jumped my micro 3+feet in the air and smacke into walls using 12 cells and not broke a thing
.... Are you retarded? Its obviously not from crashing... But from the power of the motor.
Kingtooshy
02-10-2002, 01:26 PM
how did using a powerful motor break a stearing knuckle
and yes i am retarded j/k
tc rcr
02-10-2002, 05:28 PM
i was looking at buying a hpi one way,after reading about problems with the gh one.
vBulletin® v3.7.3, Copyright ©2000-2024, Jelsoft Enterprises Ltd.