PDA

View Full Version : losb1131 problem


ttsquirrel
04-15-2009, 08:51 AM
i know that this is gonna sound dumb but i am having a real hard timing trying to figure it out. searching didnt help.

I am trying to put on a slipper cutch, losb1131, on my mini t. the 1131 comes with an aluminum spacer. i cant figure out where it goes!!. in the instructions that came with the package, step 9 says :Slide the aluminum spacer onto the top shaft. Slide a 4x8 bearing against the space. Slide one slipper backing plate onto the shaft and the against the bearing, flat face out. :confused:

It doesnt go into thegear box. it has to go on the out side,but it makes the spur gear way to far out.:confused:

does anyone have any pics of how theirs look?

I really appreciate some help.

TT

ttsquirrel
04-16-2009, 07:44 PM
there is a bearing on the outside of the gear case? i must of dropped it and not noticed.

when you say tighten all the way down... compress the spring completely?

thanks i will check this out again.

TT