PDA

View Full Version : shakey servos, no power, no connect


microtime
08-19-2007, 10:14 PM
went to take micro out other day and the servo started shakin. Seemed bad and thought it was drawing power from battery and engine. Replaced servo but did not fix problem, Could esc have given up. Puzzeled. Please help. Thanks. By the way no power or connect so leaning toward esc. Changed batteries in tx did not help.:confused:

Big-Kid
08-21-2007, 05:34 AM
You could be having glitching issue's. That could be from something like a bad Rx, cut wire, batt pack not fully charged, bad plugs, etc.....

This will cause your truck to act erratic like "twiching" or the motor "stuttering".

Alos check the EPA's on your radio. Try to adjust them to see if the "shaking" goes away. I'm assuming you checked that nothing is binding the steering linkages from damage or something stuck?

Good luck:cool:

microtime
08-30-2007, 10:09 PM
Seems that it was esc. Replaced and runs great.:) Thankyou sir.