micro-t receiver connection problem

[MajorGeek]

when I start up my micro-t it seems to take a little while to "connect" to the radio. It doesn't matter if the radio is on before or after the truck is on. I won't lose connection, so far, when it's running and sometimes i do get delays on the throttle, i have not seen it on the steering yet. Anyone else have these problems? this problem follows me where ever i run my truck so i have ruled out interference, unless my old frigging cell phone is the source since that is always with me.

[alfred]

Check your connections to the battery to the esc, and make sure that your servo and esc plugs are all the way in....you can use a small flat tip to push the connectors in......and make sure your motor is soldered properly and the wires making contact to the motor leads.

[Big-Kid]

......and make sure the crystal is fully engaged:cool:

[4 stroken ron]

......and make sure there is a good solder connection on the Receiver antenna.
Ron