servo

[m18_racer]

micro-t servo.. anyways what i did was see if the servo saver would fit on my hs55.. ya well it didnt so i tried to change out the gears of the servos... ended up losing a gear.. so than i was like hell lemme just sodder the hs55 board on the stock servo.. well as far as that goes i ended up losing the paper of where each wire went and didnt have a small enough tip(im at my dads and using my neighbors cause my iron is at my moms) so i picked up my mess thru it in the garbage looked at it disappointedly and walked away... well anyways i realized that i would need this saver ... http://www.amazon.com/Servo-Saver-Hitec-HS-55-Mini-T/dp/B0006O90NS ... its for the mini-t but for use with the hs55 just like the micro-t .. so i was wondering if they have one that will work well with the micro-t. :confused:

HELP!!

PS: all of my parts are in minus the new chassis and battery i just have to wait for my new servo and saver!

[TheSteve]

I get the feeling that servo saver is going to be too large to fit.
Its too bad your gear swap didn't go as planned, thats a nice option. If you still have the original gears out of the Micro-T servo give the gear swap another try with another hitec servo when you get one and when you're in an area that you can find stuff that falls off the table.

[m18_racer]

well i know that that would fit but it isnt designed like the micro-t servo saver...

[mugmug]

i just busted out my Mini LST and the servo savers look very similar to the one in the pic and if that's the case then it's waaaaaaaay too big for the Micro. It looks deceptively small in the pic.

[m18_racer]

well the way the servo saver is shaped for the micro-t it wouldnt work at all with the stock arms and chassis...
i got a naro + F for 14 dollars off ebay nib,, its a little smaller than the hs55 but way faster...

[mugmug]

cool servo but what are you going to use for the saver since the Mini t one is too big?? I have a HS50 which is smaller than the hs 55 and I'm thinking just shoo gooing the original micro t saver to it.

[m18_racer]

i will not be using the stock steering links or the thing they connect to... im probally going to get some turnbuckles from my lhs and cut them in half and use those and connect it to the cirlce shaped saver that comes with the naro + F ...